Call Now

CLIA kit for Homo sapiens (Human) Fibrillin 1 (FBN1)

FBN; MASS; MFS1; OCTD; SGS; Asprosin

Description: Fibrillin 1 (FBN1)

Organism Species: Homo sapiens (Human)

Sample Type: Serum, plasma, tissue homogenates and other biological fluids

Test Method: Double-antibody Sandwich

Assay Length: 2h, 40min

Detection Range: 27.4-20,000pg/mL

Sensitivity: The minimum detectable dose of this kit is typically less than 10.9pg/mL.

 

Specifity: This assay has high sensitivity and excellent specificity for detection of Fibrillin 1 (FBN1). No significant cross-reactivity or interference between Fibrillin 1 (FBN1) and analogues was observed.

Stability: The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition. To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Storage: Store at 4°C for frequent use. Stored at -20°C in a manual defrost freezer for one year without detectable loss of activity. Avoid repeated freeze-thaw cycles.

Notes: For In vitro laboratory use only. Not for any clinical, therapeutic, or diagnostic use in humans or animals. Not for animal or human consumption.

Recovery

Matrices listed below were spiked with certain level of recombinant Fibrillin 1 (FBN1) and the recovery rates were calculated by comparing the measured value to the expected amount of Fibrillin 1 (FBN1) in samples.

MatrixRecovery range (%)Average(%)
serum(n=5)78-9682
EDTA plasma(n=5)77-9583
heparin plasma(n=5)77-9590

 

Precision

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Fibrillin 1 (FBN1) were tested 24 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Fibrillin 1 (FBN1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

 

Linearity

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Fibrillin 1 (FBN1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample1:21:41:81:16
serum(n=5)95%-101%95-103%98-104%99-105%
EDTA plasma(n=5)90-101%94-103%82-92%90-95%
heparin plasma(n=5)96-103%85-96%96-96%88-101%

 

Reagents and materials provided

ReagentsQuantityReagentsQuantity
Pre-coated, ready to use 96-well strip plate1Plate sealer for 96 wells4
Standard2Standard Diluent1×20mL
Detection Reagent A1×120µLAssay Diluent A1×12mL
Detection Reagent B1×120µLAssay Diluent B1×12mL
TMB Substrate1×9mLStop Solution1×6mL
Wash Buffer (30 × concentrate)1×20mLInstruction manual1

 

Assay procedure summary

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

 

Test principle

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Fibrillin 1 (FBN1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Fibrillin 1 (FBN1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Fibrillin 1 (FBN1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Fibrillin 1 (FBN1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related Products:

Catalog NO. Product Name Product Type Organism species
KCW217Hu Fibrillin 1 (FBN1) CLIA kit Homo sapiens (Human)
KEW217Hu Fibrillin 1 (FBN1) ELISA kit Homo sapiens (Human)
KEW217Ra Fibrillin 1 (FBN1) ELISA kit Rattus norvegicus (Rat)
LW217Hu71 Fibrillin 1 (FBN1) Biotin Linked-Polyclonal Antibody Homo sapiens (Human)
LW217Hu81 Fibrillin 1 (FBN1) FITC Linked-Polyclonal Antibody Homo sapiens (Human)
LW217Mu71 Fibrillin 1 (FBN1) Biotin Linked-Polyclonal Antibody Mus musculus (Mouse)
LW217Ra71 Fibrillin 1 (FBN1) Biotin Linked-Polyclonal Antibody Rattus norvegicus (Rat)
PW217Hu02 Fibrillin 1 (FBN1) Polyclonal Antibody Homo sapiens (Human)
PW217Hu03 Fibrillin 1 (FBN1) Polyclonal Antibody Homo sapiens (Human)
PW217Hu04 Fibrillin 1 (FBN1) Polyclonal Antibody Homo sapiens (Human)
PW217Hu05 Fibrillin 1 (FBN1) Polyclonal Antibody Homo sapiens (Human)
PW217Hu06 Fibrillin 1 (FBN1) Polyclonal Antibody Homo sapiens (Human)
PW217Mu01 Fibrillin 1 (FBN1) Polyclonal Antibody Mus musculus (Mouse)
PW217Mu02 Fibrillin 1 (FBN1) Polyclonal Antibody Mus musculus (Mouse)
PW217Mu03 Fibrillin 1 (FBN1) Polyclonal Antibody Mus musculus (Mouse)
PW217Mu08 Fibrillin 1 (FBN1) Polyclonal Antibody Mus musculus (Mouse)
PW217Ra02 Fibrillin 1 (FBN1) Polyclonal Antibody Rattus norvegicus (Rat)
PW217Ra03 Fibrillin 1 (FBN1) Polyclonal Antibody Rattus norvegicus (Rat)
W217Hu01 Fibrillin 1 (FBN1) Recombinant Protein Homo sapiens (Human)
W217Hu06 Fibrillin 1 (FBN1) Recombinant Protein Homo sapiens (Human)
W217Ra01 Fibrillin 1 (FBN1) Recombinant Protein Rattus norvegicus (Rat)